1967 GTO Manual Transmission Exhaust System

The 1967 GTO with manual transmission could have been equipped with two different exhaust systems depending on the performance. Std. Duty cars came standard with 2″ head pipes and 2 1/4″ tail pipes, HO cars had 2 1/4″ head pipes with a flat, and 2 1/4″ tail pipes. Both cars has a tail pipe that exited where the quarter panel met the bumper and pointed down and out. The tail pipe had a finished double angle cut to it unless the chrome tips were used. The mufflers were unequal length on these cars. Our reproduction exhaust systems come with the correct head pipes with correct flanges on std duty cars and available flanges on HO cars, front hangers, tail hangers, clamps installation instructions, diagrams sealant are standard as well. Ask about our concourse show package for the customer who wants their system to be a little more real than real and have all the exact correct components.

Ask about our turbo mufflers for those customers who want a little more Roar in their Tiger!

1967 GTO HO Manual Transmission System With Angle Cut Tail Pipes

1967 GTO Std. Duty Manual Transmission System With Chrome Tips

1966 - 1967 GTO Muffler Hangers

These hangers are correct for 1966 - 1967 GTO's the hangers originally had a small bulge to correspond to the bulge in the clamps that Pontiac used during the day. These clamps and hangers are an exclusive Gardner Exhaust reproduction and will put your GTO over the top in exhaust restoration correctness. The hanger pictured here comes zinc plated, and hand built with corded rubbers and button head rivets to simulate the original and are availble with any of our 1966 - 1967 GTO exhaust systems.

1966 - 1972 GTO Round Bottom Clamp

These clamps are absolutely correct for any 1966 to 1972 GTO restoration. There has never been a high quality reproduction of this clamp or the hanger above that corresponds to it. These clamps are a Gardner Exhaust exclusive reproduction they come zinc plated and are available with any of our Pontiac exhaust systems

1964 - 1969 GM A - Body Tail Pipe Hangers:

These hangers are a reproduction of the orginal hangers used on a good portion of the GM A - Body Muscle Cars. These are our handbuilt hangers with corded rubbers and our reproduction button head rivets and are for those who have to have it just the way the car came from the factory. The hangers pictured here are a Gardner Exhaust Exclusive Reproduction. A similar hanger comes standard with our kits along with the correct screws pictured here.

1967 GTO Manual Transmission Chrome Tips

These tips were an option on the 1967 GTO Manual Transmission Cars. The end of the tail pipe was cut and this tip was added. This tip therefore when installed on a properly built exhaust system would exit where the quater panel meets the bumper and point down and out.

1964 - 1972 GM A - Body Retainer

These retainers were used on the GM A - Body Muscle cars on the muffler hangers. The attaching screw first went through this reatiner and then through the rubber. The reatainer functioned as a washer to protect the rubber on the hanger. Our retainers have been reproduced from the orginal in the picture and come zinc plated. They are a Gardner EXhaust exclusive reproduction and come standard with our concours show pkg. or can be optioned for with one of our entire systems.

2 1/4 " Strap Clamp

This strap clamp was used on many of the GM - A Body Muscle Cars. It was used to attach the tail pipes to the tail pipe hangers.. Our strap clamps have been reproduced from the orginal shown here and come zinc plated with the correct sheet metal screw. They come standard with our concours show pkg. or can be optioned with one of our entire systems.