1964 GTO Exhaust System

The 1964 GTO is considered by many to be the first of the Muscle Cars and we would be amiss if we did not offer a system for these cars. These cars were equipped with 2 1/4″ head pipes and 2″ tail pipes. Splitters were an option that added a unique looking extension exiting under the rear quarter panel. Our system is reproduced from an original and comes with the correct flanges, correct head pipes with flats, correct mufflers, correct 2″ tail pipes with angle cut on full length systems, correct splitter tail pipes on splitter systems. muffler hangers, correct tail pipe hangers, correct GM style clamps, installation instructions, diagrams and sealant. Splitter hangers and splitters are on option, as well as a concourse show package for the hobbiest who wants it a little more real than real.

Ask about our turbo mufflers for a little extra roar!

1964 GTO Full Length Tail Pipe Kit

1964 - 1972 GM A- Body Front Hanger

These hangers are correct for 1964-1972 GM A-Body Exhaust Systems They come standard with any of our GM A Body reproduction exhaus systems. We offer them zinc plated built with corded rubbers to simulate the original bias tire rubbers.

1964 - 1969 GM A - Body Tail Pipe Hangers:

These hangers are a reproduction of the orginal hangers used on a good portion of the GM A - Body Muscle Cars. These are our handbuilt hangers with corded rubbers and our reproduction button head rivets and are for those who have to have it just the way the car came from the factory. The hangers pictured here are a Gardner Exhaust Exclusive Reproduction. A similar hanger comes standard with our kits along with the correct screws pictured here.

1964 -1965 GTO Splitter Hangers:

These splitter hangers are reproduced from the original above. Our hangers come powder coated chassis black built with corded rubbers and button head rivets we encourage you to compare them against originals.

1964 - 1965 GTO Splitter

These are the correct splitters for the 1964 - 1965 GTO's with the splitter package. Although thise splitters are not our own reproduction we have compared them to our originals and they are a suitable reproduction for the GTO hobbiest. These splitters are available with any of our 1964 - 1965 GTO's

1964 - 1972 GM 2" Strap Clamp

This strap clamp was used on many of the GM - A Body Muscle Cars. It was used to attach the tail pipes to the tail pipe hangers. Our strap clamps have been reproduced from an original and come zinc plated with the correct sheet metal screw. They come standard with our concours show pkg. or can be optioned with one of our entire systems.

1964 - 1972 GM A - Body Retainer

These retainers were used on the GM A - Body Muscle cars on the muffler hangers. The attaching screw first went through this reatiner and then through the rubber. The reatainer functioned as a washer to protect the rubber on the hanger. Our retainers have been reproduced from the orginal in the picture and come zinc plated. They are a Gardner EXhaust exclusive reproduction and come standard with our concours show pkg. or can be optioned for with one of our entire systems.

Sealant

Originally a clear silicon sealant was used in all the joint to joint connections on most exhaust systems. This was referred to as "grease" in the assembly manual but it was a clear sealant like the one pictured here. After analyzing original samples off our pipes and searching incessantly we came up with a match with the sealant pictured here. This sealant comes as part of any Gardner Exhaust Kit