1959 Full Size Chevy 348 Exhaust System

The 1959 Full Size Chevy exhaust system kit has been reproduced from original pipes, mufflers and resonators. This particular exhaust system used 2″” head pipes, 1 7/8″ intermediate pipes and 1 7/8″ tail pipes. The original system used both a mufflers and resonators. Original resonators were welded to the intermediate pipes and were one assembly. Our systems come with the correct 2″ inch head pipes, correct extensions and donut gaskets, correct flanges, correct 1 7/8″ intermediate pipes, correct 1 7/8″ tail pipes with correct double angle cut and flat on tip as original, as well as correct clamps, mufflers, and resonators. As with all of our systems a hanger kit is available

.Ask about our turbo mufflers for a little extra roar!

1959 Full Size Chevy 348 Exhaust Kit

1959 Full Size Muffler Hangers

These are the correct reproduction hangers for the 1959 full size chevys with dual exhaust and the 348 engine option These hangers are not one of our reproductions but currently are the only reproduction for one of these systems.

1959 Full Size Intermediate Hangers

These hangers are a reproduction of the orginal hangers used at the intermediate pipe location on the 1959 Full Size Chevys. This hanger is not one of our reproductions but at the current time is the only one available.

1959 Tail Pipe Hangers

These are the correct Tail Pipe Hangers for the 1959 Full Size Chevy with the dual exhaust and 348 option.

1959 Small Block Heat Riser

This is the correct small block heat riser for the 1959 Small Block Chevys. They come with the correct chevy big block gasket and are available with any of our Chevy small block exhaust systems.

Chevy Stud Kit

This is the correct stud kit for the 1957-1972 Chevys. This stud kit has the correct dog point on the studs and uses the correct stove nuts as original. This kit is available with any of our Chevy systems.

Extensions and Donuts

These are the correct extensions and donut gaskets that were used on all the Chevy Small blocks.

GM Clamp

These are the correct style clamps for the early Chevys. These clamps come standard with any of our GM Muscle Car Exhaust Systems

Sealant

Originally a clear silicon sealant was used in all the joint to joint connections on most exhaust systems. This was referred to as "grease" in the assembly manual but it was a clear sealant like the one pictured here. After analyzing original samples off our pipes and searching incessantly we came up with a match with the seaman pictured here. This sealant comes as part of any Gardner Exhaust Kit