1969 Corvette Big Block Manual Transmission System

The 1969 Big Blocks used 2″ head pipes and 2″ rear pipes. They matched up to the manifolds with a sized up 2 1/2″ inlet which was welded onto the front pipes on either side. Our reproductions come with the correct 2″ pipes with correct welded in section and correct rear pipes with wrinkle bends as original. This kit also includes correct mufflers with correct brackets welded on correct flanges,extensions, donuts, sealant flattened style u-bolts and open face u-bolts. Hangers, heat riser and stud kit can be optioned for at the time of ordering.

1969 Corvette Big Block Manual Transmission Exhaust System

1964 - 1974 Corvette 2" Center Exhaust Hanger

Although this hanger is not one of our reproductions it is an excellent reproduction of the original hanger and we offer it with no apprehension.

1968 - 1972 Corvette Muffler Hanger

This hanger was used to hold the muffler in place at the back of the car. Our hangers are hand built with corded rubbers come with the correct screws and attaching hardware and are an excellent reproduction of the original hangers.

1969 Corvette Exaust Tip

This is another Gardner Exhaust Exclusive reproduction. After reviewing the reproduction tips available and having them fall short of adequate we decided to reproduce the tips shown here. This tips is an essential part of any 1969 Corvette restoration. Our tips are reproduced from our original are 14ga. tubing as original and come chrome plated in show quality chrome. We encourage you to compare them to originals.

1957-1972 Chevy Extensions and Donut Gaskets

These are the correct Chevy extensions and donut gaskets that were used in the head pipes of every chevy from 1957 up until 1972. They come as part of any Gardner Exhaust Chevy Kit

Corvette heat riser

This is the correct big block heat riser for the 1969 corvettes. Our heat risers come with the correct Corvette big block gasket. Our heat risers are available with any of our big block Corvette exhaust systems

Chevy Stud Kit

This is the correct stud kit for the 1957-1972 Chevys. This stud kit has the correct dog point on the studs and uses the correct stove nuts as original. This kit is available with any of our Chevy systems.

Sealant

Originally a clear silicon sealant was used in all the joint to joint connections on most exhaust systems. This was referred to as "grease" in the assembly manual but it was a clear sealant like the one pictured here. After analyzing original samples off our pipes and searching incessantly we came up with a match with the sealant pictured here. This sealant comes as part of any Gardner Exhaust Kit